Event Booking
Web Links
News Feeds
Search - K2

Article Index


Sanding mandrels are very useful in grinding, rounding, and sanding the upper inside lips of stone vases. The transition between a flat surface and a core-drilled hole is usually sharp, rough, or even damaged. The mandrel on a die grinder allows you to shape, sand and polish this area.  Presented below is how to make and use your own sanding mandrels.




This is the way that I make ¼ inch sanding mandrels for die grinders: I start off with ¼ " round stock and cut a slot down the center to hold the sanding belt in place. Then I insert the belt end and tightly roll the belt on to the mandrel, stopping when the diameter is the same as that of the crimping ring. I then crimp the ring onto the sanding belt material.

I've broken the article into five parts:  The Mandel, Sanding Material, the Crimpers, Construction, and Usage


The Mandrel


  • For 3" belting cut the slot 2 ½" long. Rip down the center of the rod with a hacksaw or better yet a metal cutting band saw, with a table. If using a band saw leave the rod long and cut the slot before cutting the mandrel to length. If you are forced to cut short rods use vice grips to hold the mandrel, as the rod can be flipped up and into the saw blade. This is a safety issue, so keep your hands clear.

The Sanding Material

  • Silicon carbide grit. Aluminum oxide will not work on hard stone, but may work on limestone, marble,or other soft stone.
  • I use cloth backed belting, with bonded grit. D or X weight.
  • Wet/dry rating. I have some old sanding belt that immediately falls apart when used wet, it is not wet dry.
  • 3" width. I have used 2" also but when the roll wears down the copper crimp ring is into your work. Longer than 3" would be ok but may wobble too much, and bend the mandrel.
  • Where do you get 3" silicon carbide belting? Rock and lapidary shops, but the price is high. Lapidary mail order stores. E-bay, has new and surplus belting and belts, just cut the belt and roll your own. Custom belting manufacturers "Custom Sanding Belts. Com" You may even find some used belts that have unworn areas on the edges. It is easy to tear or cut a belt length wise to your desired width. 

The Crimp Ring and Crimper



  • I first started out using a crimper used for repairing welding hoses. The problem with this crimper: The largest diameter roll was only ½". Such a small diameter roll only has 5 ½" of belting on it and wears out quickly.
  • The PEX crimping system is what I now use. It is designed to crimp plastic water tubing to fittings. The crimper set comes with dies for 3/8", ½", 5/8", ¾" and 1" tubing. It sells at Lowes for about $90. Cheaper units, that use a vice or bolts to tighten the ring are also available for about $25. Rental shops and plumbers also have these crimping tools. If you roll up a group of mandrels and slide the rings over the belting, they can be transported to someone who can crimp them for you.
  • Copper PEX rings sell for about $.25 each. They are widely available.
  • When using 120 grit D weight belting, this is diameter of the roll and how much belting I will use. ½" ring: 5/8" diameter roll w/ 7 ¼" of belting. 5/8" ring: ¾" diameter roll w/ 11 ½" of belting. ¾" ring: 7/8" diameter roll w/ 17 ¾" belting. 1" ring: 11/8" diameter roll w/ 29 ½" of belting.